Sell stubble disc hydraulic LDH-10M, LDH-15M

Lumiline hydraulic disc LDH-10M, LDH-15M is designed for loosening of untreated compacted soil mechanical composition, grinding pakiatani residues dlinnostebelchatye crops, cropping weeds and other vegetation on uncultivated fields after harvesting of the main crops. Lumiline works when soil moisture 12-25%. TECHNICAL CHARACTERISTICS OF LDH-10M It is aggregated with tractors-----------------------CL(150-180 HP) Type------------------------semi-trailer Width, m------------------------10 The capacity, ha/h-------------------------up to 8 Depth, cm-------------------------4-15cm Working speed, km/h-------------------------8-12 Dimensions in working position, mm -width------------------------12600 -length------------------------8200 -height------------------------1100 Overall dimensions in transport position, mm -width------------------------4200 -length-------------------------8200 -height-------------------------1400 Weight, kg-------------------------2700 TECHNICAL CHARACTERISTICS OF LDH-15M It is aggregated with tractors-----------------------CL(180-220 HP) Type------------------------semi-trailer Width, m------------------------15 The capacity, ha/h-------------------------15 Depth, cm-------------------------4-15cm Working speed, km/h-------------------------8-12 Dimensions in working position, mm -width------------------------17600 -length------------------------10912 -height------------------------1600 Overall dimensions in transport position, mm -width------------------------3026 -length-------------------------10100 -height-------------------------1820 Weight, kg-------------------------4200 Lumiline designed for peeling the soil to a depth of 4-10 cm) after harvest of cereal crops. It can be used to care for pairs, as odnoletnii disc harrows for cutting seams and grinding blocks after plowing and for butchering perennial grasses. The name of the parameter and the size of the LDH-10m The type of machine trailer It is aggregated with tractors of class, T 3 Working speed on basic operations, km/h 8 12.. Transport speed to km/h To 15 Width, m 10 Dimensions in working condition when the angle of attack of 35 (L*W*h), mm: 7600*11400*1150 Structural mass, kg 2850 Ground clearance, mm 300 Working draft, up to % 8 The total number of batteries disks, 8 pieces Frame panels pivotally connected to the bars 3, supported on the carriage 4. Each carriage consists of a beam and two self-aligning rubber or pneumatic wheels. The bars of the sections sliding rods 6 are connected to the frame. Through the bullet holes on the timber used for the installation of batteries with different angles of attack(15, 20, 30, 35°). Each battery has nine spherical disks, mounted on a square shaft. The disks are clamped on the axle between the washers, nuts tightened. The disks are cleaned from sticking soil by side-scrapers attached to the elbows. To regulate the depth of the treatment section drive equipped with a pressure rod with springs. Increasing the depth of processing on heavy soils is achieved by loading ballast into the box mounted on the frame 1 (not shown in the figure). For translation of the sections in the transport position and change the depth of tillage is designed hydraulic system. The piston rod of the hydraulic cylinder 7 is connected with the timber sections and moving rotates the beam 3, Vignoble disks from the soil. For peeling stubble field lumiline can be equipped with flat disks and device, consisting of six sections of the spherical disks intended for the formation of holes on the surface of the soil. Disks eccentrically mounted on the axle and rotated one relative to another by 180°, alternately immersed in the soil and form a deep hole 13...15 mm Depth of processing lumilikha 4. ..10 cm, width 10 m, operating speed 8... 12 km/h, weight 2450 kg, capacity 11 ha/h at a speed of 11 km/h and an angle of attack of 35°. Lumiline agregation tractor DT-75, DT-75M and T-74. Trailed disc stubble LD-20, LDH-15 and LDH-5 are different from LDG-10 is basically the number of partitions of disks. They have respectively 16, 12 and 4 sections and the width of 20