The press-pliers facilities for radial presses

REMS pressing tongs Facilities for radial presses brand REMS (except REMS Mini-Press ACC) and other suitable presses from other manufacturers

REMS pressing tongs
The press-pliers withstand very high load, made of forged and specially hardened special. Press the profile of the pressing tongs REMS-specific and corresponds used the system of press-fitting. Thanks to this flawless and guaranteed reliable pressing. Press sponge pressing tongs made REMS through precise machining on machining centers with ACPO and have just treated the press circuit.
Thanks the errors are much lower than when casting. Designed for radial presses REMS (except REMS Mini-Press ACC) and to the radial presses from other manufacturers. All marked * press pliers issued in accordance with existing patents (Patent EP 1 223 008 Patent
US 6,739,172) suitable for manual radial drive REMS Eco-Press. Read and to comply with installation guide and mounting of the seller/manufacturer system.

Choose the tongs themselves!
Find the press-pliers REMS and system press fitting according to the following table and select the required size. Note: system press fitting for pipelines can be pressure-tested only press mites/rings indicated in the table in yellow. To connect press rings REMS (PR) with the drive necessary intermediate ticks (page 140).

The control according to EN 1775:2007
The press-pliers REMS press contour M, V, SA, B, RN and UP have special marking on the press circuit, which leaves an imprint on the fitting after pressing. This makes it possible even after pressing to verify whether used for manufacturing the press-connection suitable tongs.
Using this control system, the company REMS performs the recommendations of European standard EN 1775:2007 when installing the press fitting systems for gas.