The head of the cardan 74.36.001-1, A36-C2 (soft compound) transmission PTO caterpillar tractor T 74 HTZ.
Offer type: salePublished: 17.07.2017
| Seller: |  Vladimirovich Yurij |
| Phones: |  +38 067 290 87 09 Show phone |
| Address: | Ukraine, Kharkivs'ka Oblast', Kharkiv |
The head of the cardan 74.36.001-1, A36-C2 (soft compound) transmission PTO caterpillar tractor T 74 HTZ.
The head of the cardan
Includes two discs with 4 cylindrical sockets, and pressovanye them in rubber bushings. Bonded they are using the 4 rivets and spot welding. Rubber bushings are made of cold-resistant rubber are closed in the nests of disks. To increase the strength outside their increase rubberized cloth, and inside insert and prevulcanized cylinder. frames made of metal. grid. In rubber bushings plated steel bushings, two on each side of the head. Protruding cylinder. belts bushings go into the holes of the flanges Phillips standing forks.
Middle fork, leading and being led fastened among themselves with slots and can reciprocally move in the axial direction. So you can adjust the length of the cardan transmission needed to compensate for inaccuracies in the mounting of the engine and transmission in the longitudinal e.g. Misalignment and distortions shafts HMS and the ACM compens. due to the elasticity of rubber. the collet heads of cardan.
Flanges and middle forks are also cross thereby improved compensation of errors.
The cardan little can compensate for inaccuracies, so the engine is put so that the misalignment and the misalignment of the shafts HMS and drive shaft UKM were not more than 2 mm
Leading and being led plug inside the empty cavities closed with one hand pressed plugs, cat's protect splined connection. forks from moisture and dust.
Using timoska after disabling HMS stop UKM and input shaft gearbox for their unstressed inclusion.
The head of the cardan
Includes two discs with 4 cylindrical sockets, and pressovanye them in rubber bushings. Bonded they are using the 4 rivets and spot welding. Rubber bushings are made of cold-resistant rubber are closed in the nests of disks. To increase the strength outside their increase rubberized cloth, and inside insert and prevulcanized cylinder. frames made of metal. grid. In rubber bushings plated steel bushings, two on each side of the head. Protruding cylinder. belts bushings go into the holes of the flanges Phillips standing forks.
Middle fork, leading and being led fastened among themselves with slots and can reciprocally move in the axial direction. So you can adjust the length of the cardan transmission needed to compensate for inaccuracies in the mounting of the engine and transmission in the longitudinal e.g. Misalignment and distortions shafts HMS and the ACM compens. due to the elasticity of rubber. the collet heads of cardan.
Flanges and middle forks are also cross thereby improved compensation of errors.
The cardan little can compensate for inaccuracies, so the engine is put so that the misalignment and the misalignment of the shafts HMS and drive shaft UKM were not more than 2 mm
Leading and being led plug inside the empty cavities closed with one hand pressed plugs, cat's protect splined connection. forks from moisture and dust.
Using timoska after disabling HMS stop UKM and input shaft gearbox for their unstressed inclusion.
