The automation of the boiler SP 05 LCD + fan DP02
Products of the Polish manufacturer KG Elektronik. This set is intended for automatic control of the temperature of the heat exchanger, as well as saving of solid fuel. Suitable for boilers up to 30 kW.
SP 05 LCD thermostat for boiler + fan DP02
Electronic thermostat SP 05 LCD company KG Elektronik is designed for solid fuel boilers. The thermostat SP 05 LCD liquid crystal display controls the operation of the circulation pump and the fan blowing air to the solid fuel boiler that makes it possible to maintain the boiler temperature set on the thermostat. The thermostat 05 LCD SP Elektronik KG for solid fuel boilers, produces continuous measurements of water temperature in the boiler and on the basis of the evidence regulates the amount of air supplied for combustion of the fuel. In addition, controls the circulation pump if it is in the heating system.
Functions:
soft start
antistop
thermal protection
alarm of exceeded 90°C
Blower DP-02 ELEKTRONIK KG for solid fuel boiler is used to supply air to the furnace of the boiler and for ventilation of the process equipment and premises.
Structurally, the fan, the DP-02 KG ELEKTRONIK consists of aluminum shell and an induction motor. The entrance hole is protected by a grid, the output end rectangular flange with holes for fasteners.
In addition, the air outlet of the fan, the DP-02 KG ELEKTRONIK has a metal flap that blocks the regression of the exhaust gases from the furnace of the boiler when the fan is not working.
Characteristics KG Elektronik SP 05 LCD thermostat for boiler + fan DP02
Production: Poland.
The temperature measurement range, °C: 35-90.
Hysteresis, °C: 1.
Voltage: 230V/50Hz +/- 10%.
Power consumption, W: 2.
The necessary ambient temperature, °C: -10 to 50.
Wire connection, mm: 3x0,75.
The length of the sensor cable to the boiler, m: 1.
Dimensions (W, D) mm: 150х90х60.
Degree of protection: IP 20.
Emergency thermostat, °C: 90.
Fan KG Elektronik DP-02 ALU:
The fan consists of two parts - aluminum body and engine with the rotor. Use the fan to blow air in a boiler furnace. Also, the fan may be used for ventilation and process equipment.
Production: Poland.
Engine type: K20/84.
Power consumption, W 80.
Maximum productivity, m3/h 150.
Weight: 1,5 kg.
Power Supply: 230 V / 50 Hz.