Will sell the pump unit of the CNS (G) 105-98 official dealer

Sectional centrifugal pumps CNSG 105-98 are designed for pumping cold and hot water with a temperature up to 45 ℃ and OS respectively.

PH of the pumped medium is PH 7-8,5, with a mass fraction of mechanical impurities not more than 0.1% and the size of solid particles of 0.2 mm, a hardness of not more than about 1.47 HPa.

Rotor supports two radial bearing spherical shape. The bearing brackets on a sliding fit, which allows the rotor to move to the value of the "progress" of the rotor in the axial direction.

The output of the pump shaft from the bearing housing is sealed by the cuff.

Pumps CNSG include a number of sections (2 to 10). The section consists of the impeller, casing, guide vanes, guide vanes.

The multistage design CNSG
Sectional centrifugal pumps modifications CNSG 105-98 - gorizontalnye, complete sections from 2 to 10 pieces

Pump modifications CNSG 105-98 consists of a housing and rotor.

Case includes: cover suction and discharge pipes, brackets, building and directing apparatus with the alignment apparatus.

The rotor includes a shaft with impeller, drive hydraulic heel and spacer sleeve.
For pumps CNSG 105-98 the pressure at the inlet to the pump should be no more than 0.3 MPa (3 kg/cm2), inclusive. For pumps CNSG 105-98 the pressure at the inlet to the pump shall be not less than 0.1 MPa (1 kg/cm2 and not more than 0.3 MPa (3 kg/cm2), inclusive.

The pump part of the unit and the electric motor are installed on a single base plate. The horizontal variance when setting must be greater than 0.3 mm to 1 m, and the deviation in alignment of the axis of the shafts of the pump and motor may not exceed 0,05 mm