The granulation line

Set of pelletizing plantincludes the following nodes:

· granulator - pneumatic transport of dry raw materials, pneumatic transport of the appliance-chiller, hopper-dispenser - up to 5 m.a cube., press Ohm 1,5, rollers, matrix, the conveyor is ready for the masses, cooler-sifter, Noria finished granules, weight batcher, bunker ready granules;

· drying equipment - furnace, hopper, cyclone, support and visor for cyclone, motor-reducer (screw feed), fan VVD, pneumotropica, frequency Converter, a temperature controller;

· the Cabinet control line training materials and equipment;

· bunker AVM 1,5 (live bottom), 2 conveyor.

Using line OGM -1,5 can be prepared pellets of mixed fodder, straw, sunflower hulls, wood waste or other product Type stationary. Performance in the hours of work on the straw, if: kg / h diameter pellets of 10 mm 1000...1200, diameter 14 mm 1200 1300... - fodder, if the diameter of 3.2 mm to 1500, the diameter of 4.8 mm to 3000, the diameter of the granules 7.5 mm to 5000, the diameter of 10.0 mm to 6000. Mass kg 5400.

Dimensions: mm length 5385, width 4400, height (without exhaust) 6935. The diameter of the radial holes of the matrix, supplied with the equipment 8,0 mm. The electric drive. Energy indicators: total installed power of electric motors, kW not more than 95, type of current AC current frequency 50 HZ voltage watt 3x380, permissible voltage from nominal % -7,5 to +10.

Line granulation intended for the production of fuel pellets from organic, renewable biological material. For the production of pellets with a wide distribution received such materials, as wood, manure, bird droppings, the husks of sunflower seeds, remnants of cereal crops, waste, peat. However, any material should be suitable for this kind of processingthat must match the requirements of size and humidity. For line characterized by the presence of the following units: bunker supply of raw materials, drying the complex drum type on the basis of AVM 1,5 and himself granulator, meets all the requirements of safe operation. Additional lines can be equipped with grinding technique (chipping and crushing machines) for receiving material of the required size. Than less than the size of the raw material, the easier it is to extrude.