Device bridge KSM,KSM 1,KCM-1

The instruments are made in steel with dimensions ham, Board modification. On the front of the unit is a registration system, the toggle and the alarm "Device enabled" toggle - move chart tape. On the top panel under the hood is the signalling control system, the scale adjustment 0-100% with this error srabatyvaniya signaling devices must not exceed +-1,5% of measured values in relation to the set values of the instrument scale. Climatic modification devices NF4.1 - the temperature at which the device can operate from +5 degrees Celsius to +50 degrees Celsius with humidity less than 80%. Depending on the modification of the devices may have:

- 2 or 3-pin positional signalling device;

rheostat output device for remote transmission of data on the backup device;

rheostat unit with a 100% proportional band to work with the device P (control device) to resolve the alarm "CHIRP" - regulation.

- additionally set the input signal Converter in a uniform current output signal (0-5 mA or 4-20mA).

The performance of the devices, not more than:

for single-point devices - 2.5 seconds. or 5 seconds. depending on the modification;

for multipoint devices, but not more than 6 channels - 2.5 seconds. or 10 seconds. depending on the modification;

The width of the ribbon diagram: 100mm

The speed of advancement of the ribbon diagram:

- for single point devices selected from a range of -10, 20, 40, 60, 120 mm/h, depending on the modification;

- XO is selected from a series- 20, 40, 60, 120, 240 mm/h or 600, 1200, 3600 mm/h depending on the modification;

The error rate of advance of the ribbon diagram no more than +0,5%;