Pneumococcal - DP-2 - pneumatic Jack
Offer type: salePublished: 28.03.2015
| Price: | 1 750 UAH |
| Company: | servisto.artem@gmail.com |
| Seller: |  Bondarchuk Artem Myikolajovyich |
| Phones: |  0677778215 Show phone |
| Address: | Ukraine |
The Jack is designed for use on various HUNDRED and tire shops. Using a pneumatic Jack, you can draw out the wheels of cars, vans and light trucks without physical effort. The design of the Jack can lift cars with relatively low clearance.
The height of the Jack can be used to lift almost all passenger cars.
The load capacity of the hoist is determined by the operating pressure in pneumonology and ranges from 1 ton (at a pressure of 2 ATM.) up to 2.5 tons (at a pressure of 6 ATM.).
Our company recommends that you complete tire repair shop (given the expected load) pneumatomachi in a ratio of one DP-2 to two DP-3.
Raising the car: put DP-2 in the desired location under the bottom, connect compressed air and to open the valve. Raising the car to the desired height, shut off the valve.
Lowering auto: disconnect the compressed air to open the valve.
In order to avoid failure of the telescopic stabilizing device inside corrugated chamber, the load must be positioned exactly in the center of the Jack
The height of the Jack can be used to lift almost all passenger cars.
The load capacity of the hoist is determined by the operating pressure in pneumonology and ranges from 1 ton (at a pressure of 2 ATM.) up to 2.5 tons (at a pressure of 6 ATM.).
Our company recommends that you complete tire repair shop (given the expected load) pneumatomachi in a ratio of one DP-2 to two DP-3.
Raising the car: put DP-2 in the desired location under the bottom, connect compressed air and to open the valve. Raising the car to the desired height, shut off the valve.
Lowering auto: disconnect the compressed air to open the valve.
In order to avoid failure of the telescopic stabilizing device inside corrugated chamber, the load must be positioned exactly in the center of the Jack
