Gearboxes three-zu
Offer type: salePublished: 19.04.2013
| Seller: |  Pirozhkov Yurij |
| Phones: |  8(47241)7-57-73 89040847678 Show phone |
The cylindrical three-stage horizontal General engineering application types TU-160, TU-200, CW-250 (CU-160, CU-200, CW-250) is designed to increase torque and reduce speed.Conditions of use of the gears -200, CU-250, TU-160:load constant and variable one direction and reversible work long or with periodic stops the rotation of the shaft in either direction, the speed of the input shaft must not exceed 1800 rpm ambience of the types I and II with dusty air is not more than 10 mg/m3;climatic performance, T ( for placement category 1...3 ) and climatic design UHL and On ( category 4 ), and TU-160 climatic performance holdem placement category 1...3 supplied gearboxes CU with gear ratio 8,10,12,16,20,25,31,5,40 and the circuit Assembly No. 11,12,13,16,17,18,21,22,23,26,27,28,31,32,33,36,37,38
value of the permissible torque and radial cantilever loads gearboxes CU-250 with the cylindrical end of the output shaft must be reduced by 20 percent, ratio 16, 20, 25 should be reduced by 30% permissible radial load on output shaft for variations Assembly 13, 23, 33 and the input shaft 31, 32,33,36 of drinaballerina twice when the gears in reverse permissible torque at output shaft must be reduced by 30%.
value of the permissible torque and radial cantilever loads gearboxes CU-250 with the cylindrical end of the output shaft must be reduced by 20 percent, ratio 16, 20, 25 should be reduced by 30% permissible radial load on output shaft for variations Assembly 13, 23, 33 and the input shaft 31, 32,33,36 of drinaballerina twice when the gears in reverse permissible torque at output shaft must be reduced by 30%.
