Spare parts for compressor installation NRE

Block screw CF-128LG, gear ratio i=1,2115

83900972 Set of seals for bearings CF128G/G2/LGЗ

Block screw CF-128LG, gear ratio i=1,2115
83900972 Set of seals for bearings CF128G/G2/LGЗ
Engine AMM N=wt; n=3000 rpm; 380/660V; use IM2001; IP 54;50 Hz; class F insulation
Engine AMUS; use ei 2001; 380/660 V;N=wt;n=3000 rpm IP 54;50 Hz; class F insulation K3-2 C. 1/337.11.5 with bearings and grease SKF
The heat exchanger SS 132 kW soff (cooler only) firm "EXCEPTIONAL" Italy
Asynchronous electric motor 7,5 kW 380/660 V, 50 Hz
The motor AV, Mont. use IM3031 N=1,1 kW; n=1000o6/min degree of protection IP54, insulation class F frame material-aluminum alloy with the screw resp. on the shaft
The impeller 730/12-12/30/PAG/5ZL/22/6/AND
43.42.84.019.01.01.000 Clutch
43.42.84.016.05.01.001 left half coupling (compressor unit)
43.42.84.016.05.01.003 Finger
43.42.84.016.05.01.004 Sleeve spacer
43.42.84.019.01.01.001 the Coupling half right
S.008.001-01 Ring elastic K3
43.42.84.018.12.00.000 Valve suction
43.42.84.017.28.00.004 Disk
43.42.84.017.28.00.006 Disk presser
43.42.84.018.12.00.001 Shaft
43.42.84.017.28.00.007 Sleeve
43.42.84.017.28.00.007 Sleeve
43.42.61.063.08.01.105 Axis
43.42.84.017.28.00.012 Ring
43.42.84.018.12.00.002 Disk
43.42.61.062.11.05.000 Basket
43.42.84.017.28.00.013 Screw
Paronite gasket: MBP-2.0 GOST 2181 80 G/206mm
43.42.84.019.08.00.000 System idling and throttling performance
43.42.61.034.18.02.000 release Valve (used in modernized KU)
43.42.61.020.23.12.005 Ring sealing
43.42.61.020.23.12.006 Membrane
{ used in older models)
The valve membrane PZ 26237-015.16
Membrane 302662.001
Gauge M-R
Pneumatic cylinder with spring return HRC 50x32-II (applied earlier)
Pneumatic cylinder 40N1L050A0032C01 (qualitative analogue of HRC 50*32-II)
The pressure regulator N1208-ROO
Electropneumatically 3/2 with electrical control series "6": 638-150-AE; U=220V; 50 Hz
The filter 208 N-FOO-C01
Fitting mod.1410-8/6-1/8
Fitting mod. 1500-8/6-1/4
Fitting mod. 1510 8/6-1/8
Fitting S2500-1/8
A special connector mod.124-800
Tube Wilsonova mod. Th PA11SR Neutro-Cod T86TSR
099873220 Monark Clamp coupling D=20...32MM H=9mm
The rubber sleeve with natanam gain h-1,6 HOST-76
43.42.61.034.19.05.000 minimum pressure Valve
43.42.61.034.19.05.001 Slider
43.42.61.028.46.01.007 Gasket
43.42.61.034.19.05.003 Spring
753 513.001-57.04 Spring
ST-P Cuff 1-090-2 GOST 18677-75
O-rings 008-012-25-2-5 GOST 9833-73 / GOST 18829-73
laying Biconic SMM; f x closed gymnasium T10;
laying Biconic 4mm; f x F50;
43.42.84.019.23.00.000 Valve
43.42.61.022.11.01.100 Flap
43.42.61.022.11.01.101 Disk
43.42.61.022.11.01.102 retainer Ring
43.42.61.022.11.01.103 Washer
C 754 152.062-2O. O2 Spacer And-100-10
Biconic 2mm, d88хd57
Pneumatic valve safety P-CAP 25 Q=20 M3/min Pnom=1MPa
43.42.61.028.20.14.000 temperature Controller '
43.42.61.028.20.14.009 Spring
43.42.61.028.20.14.010 Spring
43.42.61.028.20.14.011 Paronite Gasket MBP-2.0 GOST 481-71 ф73h14хф58Н14
Thermo sensor TC-60 TO-00227459.101-95
43.42.61.043.27. PA.000 drainage
The electropneumatic valve direct acting 2/2. series 6 623-15F-AE U=220B 50Hz
a special connector Mod.124-800
Ball valve with steel body mod. 2930-1/2; DN15; PN10.
Filter oblique net with blank DN15 PN16
43.42.61.043.40.00.000 Compensator
Bellows 105-10-0.H GOST-3338-76
The absorber was AXS-300M GOST 17053.1-80
43.42.84.019.31.00.000 Hose DN 32 Sleeve RVD-1-S-N DN31 L=mm
43.42.84.019.31.00.000-01 Hose DN 32 Sleeve RVD-1-S-N DN31 L=,m
43.42.84.019.35.01.000 Sleeve RVD-1-$-N DN31 1: -460mm
43.42.84.019.33.00.000 heating System oil
43.42.84.019.33.03.000 Device heating oil
43.42.84.018.27.01.300 Block heater
TEN-B/1.6 Z 220 NF4 GOST 13268-88
The rubber sleeve 25-35-1.6 GOST-76 L=400mm
The rubber sleeve 25-35-1.6 GOST-76 L=750 mm
The rubber sleeve 25-35-1,6 GOST-76 L=900MM
43.42.84.019.34.00.000 heated oil. Electrical equipment and instrumentation A.
Electric household vortex brass WB 0,25-20 U1.1
The ball valve Art.600/45 ДN25; PN16
09987.3225 Mopah Clamp coupling for hose DN 25...40 mm; H=9mm
The rubber sleeve 25-35-1.6 GOST-76 L=400mm
The rubber sleeve 25-35-1.6 GOST-76 L=-750 mm
The rubber sleeve 25-35-1.6 GOST-76 L=-900mm
43.42.84.019.35.00.000 Pipeline injection
The sleeve RVD-1-S-N DN31 L=460mm
43.42.84.019.35.00.002 Gasket Sheet DPRM-2,0 MH GOST 495-97 F40/f,5
43.42.84.019.38.03.000 filter Pack
Gasket, Biconic 2 mm, 55 HP mm TU 25.1-30664881-001-2001
Laying Biconic 2mm TU 25.1.30664881-01-2001 f (-0.43) x f (+0.36) mm
The filter element with filtration 40 microns. FENG, FFh, mm
The filter element with filtration km. FENG, FFh, mm
S. OO-88. O4 Spring
43.42.84.019.38.00.001 Paronite Gasket MBP-2. About GOST 480-80; ф14Оh4 x FNM
Laying Biconic 2mm, ф75h