Balancing it with their own hands. Is the balancing in house conditions?

Balancing in house conditions it is today with the simple and low-cost System BALTECH VP-3470 or the new Auswuchtgerät the Series BALTECH VP-3470 possible. Balancing is quickly and accurately with own Hands in 3 steps: measurements - calculation of the Ausgleichmassen installation. But there are also Auswuchtfehler and reasons, the balancing affect .

So you have to be aware of the following:

1) balancing is impossible, if the rotor geometry is faulty. So if you are using the car in a pit fall or quickly against a Kerbside encounter, the disc of the wheel, thereby bent. In Car service you will say: "balancing is at the Moment not possible, you must only the disc of the wheel meshing“, i.e. it must be only the slices (in our Case Rotor) Geometry restore.

2) balancing is impossible, if the system storage or Fundamentfehler. In this case, one observes increased vibration, the homemade balancing can affect.

Auswuchtfehler:

- Vektorausgleich (Add up and Subtract vectors always leads to the errors),

User and other errors (incorrect weight and angle adjustment for different Masses)

- graphical Representation

Control the Datenwiederholbarkeit (stable measurements)

Function from the Multiplexer (data from different channels is faulty)

For easy balancing with your own hands, or the Balancing in - house or operating conditions of the device BALTECH VP-3470 a menu of "BALANCING", the following classification:

- 1-Plane Balancing. The mode allows balancing of rotating Parts with the Diameter greater than the length of with your own hands.

- 2-Plane Balancing. The mode can be Balancing of rotating Parts on two bearings in house conditions .

- N-Tier-Balancing. The mode allows balancing of rotating Parts, the n-layer to the balancing have with your own hands.

Calculator. The mode allows the weight of the Ausgleichmassen and their angular adjustment on the basis of the existing data for the amplitude and Phasenschwingung.

- Additional Balancing. The mode makes the balancing with the use of previously stored data with their own hands.

- Vektorkalkulator. The mode can be points for Attaching Ausgleichmassen, if it is impossible 's mass at the recommended point to install.