Code: ST-42
Max. load, Watts: 1200
Detection angle: 360
The distance of detection, m: max 6
The speed of object detection, m/s: 0,6-1,5
Delay: 10sec - 7min
Operating temperature: -20...+40
IP protection: 20
Power supply: 220/240 50Hz
Mounting height, m: 2,2-4
Illumination LUX: 3-2000
Dimensions, mm: 75,6 x 100
Warranty: 3 years
The motion sensor from the German company Euroelectric, which is mounted in the ceiling on the principle of point lights (it is fixed there with the help of small antennae).
This motion sensor has a detection angle of 360 degrees and the distance at which he is able to capture the movement, reaches 6 meters. Thus, the detection speed is only 0.6 to 1.5 m/s.
Before connecting the motion sensor ST-42 it is important to remember that the maximum load that can be served on him, shall not exceed 1200 Watts. Given that paired with motion sensors often put the led light sources, this power is more than enough.
For most efficient operation, this ceiling motion sensor should be installed at a height of from 2.2 to 4 meters, in areas where the temperature ranges from -20 to +40 degrees Celsius.
For more setup on the motion sensor (lateral) placed two controls:
"LUX" is a controller that allows you to set the light level of the environment where the sensor will not work. For example, in the afternoon, when the room has enough natural light.
"TIME" - this knob sets the time of illumination of the connected light sources, after it was detected motion. You can set any time range from 10 seconds to 7 minutes.
It is important to note that the motion sensor Euroelectric ST-42 has protection IP20, so it must be used in enclosed spaces. Most often, these sensors are installed in offices and warehouses.
Warranty motion sensor is 3 years. from the date of purchase.
If You have questions, or need advice on if the motion sensor is ask right now.