Punch hydraulic sheet metal PGL-N stock

The hammer drill is designed for hydraulic cutting holes etc. to 60.5 mm, sheet metal thickness up to 3 mm and D. 115, 5 mm metal thickness up to 2 mm

Punch hydraulic sheet metal PGL-N STOCK

Package contents:

The pump sleeve WFD and BRS - 1 piece
Press for punching PG-60+ -1pc.
The set of nozzles "Punch-matrix" for punching round holes- 22; 28; 34; 43; 49 and 60.5 mm
Pin 11mm.-1 piece

Purpose:

Punch hydraulic pump is used for cutting holes up to a diameter of 60.5 mm, sheet metal thickness up to 3 mm and diameter 115, 5 mm metal thickness up to 2 mm with the prior by drilling the holes for the rod.

Advantages:

The Association of one set of well-proven punch PG-60+ and lung pump helped to create a light and practical starter set for perforation of the most common in production holes.

Description:

The tool is a hydraulic pump connected through quick coupling with high-pressure hoses to hydraulic press with integrated hydraulic piston, resulting in the movement of the pin with a punch.

Procedure:

Connect the pump to the punch with high-pressure hoses (WFD) through the quick coupling (BRS) . Tighten the coupling The PRS.

-Drill in the processed metal sheet hole for the pin. For cutting holes up to a diameter of 27.5 mm advance drilling diameter not less than 11 mm under the pin of small diameter. For cutting holes with a diameter of 34 mm advance drilling holes with a diameter of 15mm.

-Screw in the working part of the piston pin corresponding to the selected the diameter of the hole. Stiletto wrapped side with less the number of turns of thread.

-Tighten the stud with a wrench. Do not use excessive force when tightening.

-Put on the stud cylindrical spacer.

-Put on the pin matrix of the desired diameter.

-Holding hand matrix, insert the stud into the hole in the sheet metal.

-Tighten the plug on the stud from the back side sheet metal.

-Install the wheel valve of the tool in the Closed position.

-Shaking the handle of the tool after cutting holes in sheet metal.

-Install the wheel shut-off valve in the "Open"position.

-Unscrew the plug and remove the cutting.

If the pump is used with other interchangeable nozzles pay attention to the fact that the working parts are interchangeable heads always a small amount of oil. Periodically check the oil level in the pump and pour the oil as needed. For this must Unscrew the metal casing of the pump, open plastic tube on the rubber tank, add oil up to a maximum and gently wrap the tube in place.

 

Security measures:

-When using the tool, observe the sectoral and industrial safety measures.

-During operation, observe the technical parameters. The mismatch of the processed parameters of technical metal the characteristics of the tool will lead to its failure.

Conditions of storage and transportation:

Operating temperature -15...+ 40(C.

Temperature transport -25...+50(C.

Relative humidity 20 - 90 % non-condensing.

In case of finding the products at temperatures below -15(before you begin you must press withstand 3 hours at a temperature above +10(C. otherwise, in the beginning of a possible leaking oil the area of the seals that will not be a warranty this opportunity.

Warranty:

The warranty period is 36 months from the date of sale, when the rules of work, conditions of transportation and operation at the presence of filled passport stamps on sale.

The warranty does not cover consumables: matrices, punches, pins, blades, sponges, cutting elements, paintings, etc.