Sealant GED-1

GED-1 TU 38.303-04-04-90

GED-1 is used for surface sealing of structures, devices, resistors, for sealing joints on the exterior of the freezer and refrigerated chambers and repair products, sealants sealed VIXENT. GED-1 does not cause corrosion of aluminum alloys anodized, non-clad, silver coatings, carbon steel. Clad with the filling of the anode film bichromate, silver coatings, carbon steel. Bonding aquariums, sealing of electronic equipment. Operating temperature range from -60 to +250°C.

Sealant GED-1 is used for bonding metallic and non-metallic surfaces - glass, concrete, wood, rubber, plastic, ceramic tile, etc. GED-1 is used for sealing constructions equipment, devices, resistors operating under conditions of constant vibration, "hot seams, joints on the exterior of the freezing and refrigerating chambers, connections in parts of engines (as autoprocedure), the sealing riveted and screwed connections, including pipelines for hot and cold water.

Sealant GED-1 does not cause corrosion of aluminum alloys anodized unclad or clad with filling of the anodized layer is chromium, silver coatings, various steels. Is the sealant GED-1 on THE 38.303-04-04-90.

Sealant GED-1 heat-resistant - retains operational properties at temperatures from-60C to +250C. The sealant GED-1 absolute water resistance and resistance to atmospheric agents and UV radiation. GED-1 sealant is easy to use: application temperature from-30C to +60C. Sealant GED-1 is a high-viscosity (do not drain with vertical seams, does not spread), as well as reactive.

Safety requirements the sealant GED-1 does not apply to hazardous products in solid state is absolutely no harm to health.
Specifications GED-svoistva / brand GED-1
Density, 1,9 GSM
Temperature -60 to+250°C
Vulcanization 15-18°C
Viability, not less 0,17
CONV. Tensile strength, MPa, not less than 2.0
Otnositnlno outlinee at break,%, not less 250-600
Shore hardness a., CONV.ed., not less than 28
Bond strength when peeling from aluminum alloy D16 (gap material or peeling on the grid), kN/m, not less than 1.7
Volume resistivity at 20°C, Ohm.cm 1-1013

Packing:
the aluminum tube 300 gr.
Shelf life:
12 months.

Sealant GED-1 is applied to degreased with benzene, alcohol, or acetone clean dry surface layer of 2-3 mm, after which connect the surface and gently pressed to each other. Setting time of 10 minutes Maximum strength is achieved in 24 to 48 hours. After applying the tube tightly closed.