suggest to buy inexpensive Petkus of selectra

3. Principle of operation
Be treated seeds get into the machine from
the boot of the bucket (I) through the drum feeder (2),
placed on an elongated bracket sieve mill. For
achieve continuous supply of hard-to-loose and prone to
the roll felt in the seed that is buried seeds constantly
mixed by using a mixer (3). The number
incoming seed can be changed by using
regulating valve (4). During the passage of seeds to
sieve I (5) in the mine prior separation
(6) air flow vysasyvaya light particles and
obespylivaetsya seed. In the separating cavity (7)
separated impurities from the dusty air and displayed in
point (A). Pre

Fig. 2 normal Machine manufacturing looking with
on the drive side. Protective device removed for
the best survey.
Cleaned the seeds fall on the top sieve (8)
techrestore mill. On the top sieve separated coarse
dirt and impurities out of the sieve mill point
(In). Failed seeds are on the middle sieve
(9) and the lower sieve (10) further sorting. Then
as approvalonline through a medium sieve waste out
in point (C), sand, small weed seeds and not
fully developed seeds together into the tray
(D). Lower and middle sieve constantly cleaned
brush devices (11). The upper sieve (12)
cleaned the beater. Purification of the sieve mill
ends pass through a watch main separation
(13) where is the separation speed in
a suspension.
Raised by the air flow light seeds and weeds
fall in separating cavity (14), where they
deposited in and out in point (B). Centrifugal
the fan (15) drives the dusty air and preliminary
the main separation through fileprovider pipe (16) and
dusty camera out.
Still remaining in the dusty air of particles of chaff
removed machineitem (17) and shown at the point
(G). With two regulating valves (18, 19)
adjusts the speed of the air flow channels.
Cleared in the air stream and on the sieves seed out
from the machine at the point (N).
4. Technical data
Type machinic 218/1
Weight Rashad,042-0,1 kg/c (0,15-0,35 t/h) at
seeds of forage grasses, depending on species
seeds, pollution degree covered seed and
patterns of impurities.
Need for power:1.5 kW
Speed: motor:
fan:
drive shaft for sieve mill:
                                                                                 
1440 rpm
660 rpm
430 rpm
Performance (by air)1.4 m3/sec
Dimensions:
length:
3100 mm
width:1900 mm
height:2800 mm
height with stand:3200mm
The weight (mass) without stand:1000 kg