Printout of a honeycomb MP-2 Pufler. Respectively framework.
Offer type: salePublished: 19.05.2019
| Seller: |  Aleksandr |
| Phones: |  +380509652060 Show phone |
| Address: | Ukraine, Zaporiz'ka Oblast', Berdyans'k |
Respectively of the electric part in perfect condition.
All as new, working, no defects.
Bought Vladimir Putler Novomoskovsk in 2018.
Used 1 season in August 2018года.
Sell as unnecessary (due to the large decrease in the number of families).
Features
Works very fast, fully or partially
a sealed framework.
Prints of any frame 145mm 230mm,300mm.
1 minute can be printed from 3 to 8 frames.
Neatly prints the frames with brood:
brood lowered spindles and printed
only the top of the frame and the brood remains untouched.
If there are small nerespectarea areas near the brood,
they open with a fork or knife and put into the tank.
In the tank fit the frame 21.
Zabrus through the hole of 100x100 in the bottom of the tank
falls in the bucket or cans( to put under the tank).
Engine you can enable in any position of the frame.
The motor is activated by foot (switch at the bottom, near floor).
Powered by a 12 V battery. or from 220V through
power supply 400W (included).
Specifications:
1. Dimensions:
length 1100(mm)
width 600(mm)
height 800(mm)
2. Weight 32(kg)
3. Supply voltage -12(In)
4. Engine power 250(W)
5. Time of printing one frame - up to 5(sec.)
8. Regulation limit the depth of printing 19-25(mm)
9. The volume of the tank - 21(framework)
Can provide more photos.
Send to Ukraine:
OLX delivery, or Intime cod.
New, now worth 23000грн.
