Water heater electric tankless Stiebel Eltron 6 kW hydraulic UPR-e DHC 6 (220V)!

Water heater electric tankless Stiebel Eltron 6 kW hydraulic control DHC 6 is designed for heating sanitary water non-potable water hot water system to service one or more points of demand (sink, sink, kitchen sink, shower). The device heats water directly at the point of selection, when needed. Due to the small length of tubing to the point of water separation provided by a low level of losses of energy and water. The electric heating element has a copper surface not destroyed by corrosion and have high conductivity, supplied from a household outlet with a voltage of 220 V. adjustment of the temperature of the hot water produced by a hydraulic method using the mixer. Tankless water heater Stiebel Eltron DHC does not have a storage tank, therefore, is characterized by compact dimensions, reliability and durability. By design, the water heater is pressurized, that is, crashes into the water and is under constant pressure (from 0.6 up to 10 bar). Automatic switching on of the heating system takes place directly after opening the hot water valve on the valve – supplied water is heated. This process is a built-in valve with relay and adjustment of the water temperature at the outlet of the device is infinitely variable by hydraulic method. Safe work tankless electric water heater Stiebel Eltron DHC is provided by a dual protective system that protect it from overheating, and special protection from the sudden water pressure drop. With increasing temperature above the specified critical value, disconnected the heating element from the power supply. Electrical safety the device complies with IP 24, which means smooth operation and full protection of user from electric shock even if the case fall water spray from any direction. The electric heating element of the heater is a copper tube, through which cold tap water. On top of the bulb sensors are two-stage protection system from overheating. When the water temperature reaches 65 ° C, triggered the first stage, reducing the intensity of heat. When the temperature drops, full power turns back on. The second stage of work, when suddenly the temperature rises to 100 OS. Happens all power is off and the indicator light will indicate a problem. The housing of the flow heater has a flat rectangular shape and made of plastic. The device is mounted on the wall close to the points of demand both by open and closed method. The connection tubing, the lower joining G 1/2". Call +7 911 9256840 Write: oooteplomir@ya.ru