New! CSI 2140 BALTECH exclusive provider and training center for vibrodiagnostics
| Seller: |  Roman Romanov |
| Phones: |  (044) 392-29-15 Show phone |
| Address: | Kyiv, Ukraine |
Time is often critical factor when performing vibration analysis equipment on a given route. When you want to check out thousands of pieces of equipment is a large and complex task. Training monthly courses PU-201 principles of vibration always discusses issues, how to organize the activities of the Department of vibrodiagnostics using a high-speed 4-channel vibration analyser CSI 2140, with minimal staff specialists. In addition to surveys on routes serving staff often performs specific tasks advanced diagnostics, such as the assessment of coherence signals, testing the acceleration/coasting, modal analysis, cross correlation analysis and structural analysis. All this is done to determine technical state machinery and identify emerging problems.
For vibration analysis on routes using one-, two-, and even some four-channel analyzers required on several occasions to put the sensors on each bearing. And this is only in order to perform measurements on several fronts. This volume work, especially if you want to explore the thousands of pieces of equipment.
Do not spend on data collection time, which may be required for more important tasks.
Turn the test procedure vibrations in a faster and more efficient process, allowing you to gain valuable information for Troubleshooting and resolving problems on the new level. Find the sources of the most difficult problems of the equipment. The company BALTECH recommends be used for vibration monitoring and vibration analysis advanced patented technology.
New! CSI 2140 BALTECH exclusive provider and training center for vibration diagnostics.
Use the patented accelerometer with three axes of sensitivity and built-in magnet for collecting data about vibration in three directions at the same time. These data, in combination with data from PeakVue analysis, help on the early stages to identify the development of defects in the bearings and gear the gearing.
http://www.baltech.com.ua baltech.ua@gmail.com, t/f: (044) 392-29-15
