Bizator  /  Adverts  /  construction industry  /  building materials  /  heat insulation, sound insulation, waterproofing

The Wind Barrier Membrane

Offer type: salePublished: 11.06.2013
Seller:Shatsillo Sergej Sergeevich
Phones:
Show phone
Write a message
Address:Ukraine, Dnipropetrovska Oblast'
Super-diffused membrane designed to protect insulation and load-bearing walls of buildings from the damaging effects of wind (on the heater) and wet
Features super-diffused membrane wind barrier:
1.Preventing moisture insulation (due to the possible ingress of rain drops in a ventilated air layer of the facade);
2.To prevent possible air flow;
3.Ensure drying of the insulation and the exterior wall construction.
Dignity super-diffused membrane wind barrier:
Waterproof
This property protects the internal structures from the effects of wind and water at a pressure of 500 mm;
Airtightness
In multi-storey buildings for hinged facade may occur a so-called "effect of the wind tunnel". The wind howled between the two membranes, causing significant heat loss (according to some sources up to 25%). When this occurs, the delamination of the insulation on the fibers and their subsequent partial separation and loss of the heat-shielding properties. In addition, to achieve absolutely tight junction insulation boards to each other is almost impossible (this is due, as a rule, with the irregularities of the solid walls), which, naturally, causes a loss of heat.
The water vapor permeability
As a result of pressure of water vapor inside the room, especially in winter, there is an accumulation of moisture in the insulation. So she went into the ventilation gap, windproof film should "breathe". This property is very important; otherwise violated the basic functions of ventilated facade system. Breathable windproof film (membrane) freely transmits water vapor coming out of the heater.
Installation:
The film is mounted directly on the plane of the rafters or other construction elements of the roof. For this purpose brackets with mechanical installation or stainless nails with flat hat. The fabric membrane connected overlapped on the dotted line. Joints it is recommended to glue the adhesive tape K-2. When laying the green side of the membrane should be facing outwards (upwards).
LLC"alpha" 096-098-52-70, 050-293-59-16 Sergey