Good price on the machines for the manufacture of cinder blocks in the winery.

Install the machine on a flat surface (preferably concrete floor);
To omit the matrix on the floor, lifting lifting lever and press the locking matrix limiter;
The second lever to raise the matrix with voids and to take her to the end position from themselves;
Made the dough in the mixer is quite hard (semi-dry) concrete. Water cement ratio not more than 0.5. Grade of concrete - 100 (and more). Preferably without clay and organic investments;
Loading the hopper of the machine (forms) with a small "hill". Preliminary vibroplate within 0.5 to 2.0 C. not more (depends on the humidity of the concrete)! When this pre-shrinkage (5-10%) of the concrete mixture and filling the form itself. Optionally, Stikovica concrete in the corners and other places. Excess concrete is cut and removed, the remains can be placed for receiving the front bar. For this you may use a specially made boot scoop or trowel;Buy vibrotek for blocks
Final vibroplate mixture for 15-30 seconds occurs with the upper clamping frame before their limiters;
To take two hands for lifting the lever and make the ascent of the matrix. Raising the matrix to produce with the included vibrator (vibration should be small);
After picking up the matrix, the terminator himself commits the matrix in the raised condition;
The unit is ready, and the machine moves to the rear wheels slightly lifting from the front shock absorbers for the handle, and is installed in the original position for making the next block.
 
Rules of operation:

To enable the machine to the network 220 with a grounded wire.
Time machine is running short (up to 2 minutes continuously).
The motor of the vibrator should not overheat.
Water (moisture) and the solution should not get on the on/off switch on the motor housing and the current-carrying wire.
After the operation, the machine must be cleaned, and wipe clean oil cloth surfaces.

PS-200 Machine for the production of wall block
Intended for the manufacture of wall blocks of different voidness based on a variety of fillers.

Production of blocks is carried out by semi-dry pressing.
The molding is made removable pallets, which reduces the production of space by stacking methods.
Enables the production of wall blocks with accurate geometrical dimensions, stable characteristics of density, strength, frost resistance and water absorption.
Provides excellent quality products due to the vibrators that provide uniform compaction of the sand.
Removable molds allow producing wall blocks of different shapes and sizes.
Performance from 1100 pieces per shift is due to the possibility of making two building blocks for one cycle of pressing.