Booth M-E-CR
Offer type: salePublished: 22.08.2018
| Seller: |  Netunaev Andrej |
| Phones: |  (34369) 47351 Show phone 47751 Show phone |
| Address: | Berezovskiy, Russian Federation, Sverdlovskaya Oblast' |
Stands M-E-CR intended for test and adjustment of automotive injectors of diesel engines and diesel injection system Common-Rail: electromagnetic production of BOSCH, DENSO, DELPHI and piezoelectric production of BOSCH, DENSO, SIEMENS, removed from the engine.
- Pressure at the beginning of injection;
- The quality of fuel atomization;
- Leak shut-off cone;
The density of the spray-on shut-off cone and the cylindrical part (time pressure).
In the stands there is a direct fuel line to check the vibration of the needle and the sound characteristics of the nozzle.
Measuring stand M-E-CR produced high-precision pressure sensor and displayed on the display of the electronic unit.
To test diesel injector Common-Rail in the stands built modulator signals "Common Rail Tester". The modulator signal is applied before disassembly and defectoscopy injectors for preliminary health checks, a rough estimate of leakage, the level of contamination, or blur the spray holes of the spray. After Assembly of the nozzle by means of the modulator is evaluated for correct Assembly, if necessary, "prostukivanie" ball valve to the seat, check the opening pressure of the nozzle.
The range of the reproduced pressure, MPa (kgf/cm2)- 0...40 (0...400)
Capacity for fuel, l not less than 2
The fuel supply mm3/cycle, not less than 1200
Price on request
- Pressure at the beginning of injection;
- The quality of fuel atomization;
- Leak shut-off cone;
The density of the spray-on shut-off cone and the cylindrical part (time pressure).
In the stands there is a direct fuel line to check the vibration of the needle and the sound characteristics of the nozzle.
Measuring stand M-E-CR produced high-precision pressure sensor and displayed on the display of the electronic unit.
To test diesel injector Common-Rail in the stands built modulator signals "Common Rail Tester". The modulator signal is applied before disassembly and defectoscopy injectors for preliminary health checks, a rough estimate of leakage, the level of contamination, or blur the spray holes of the spray. After Assembly of the nozzle by means of the modulator is evaluated for correct Assembly, if necessary, "prostukivanie" ball valve to the seat, check the opening pressure of the nozzle.
The range of the reproduced pressure, MPa (kgf/cm2)- 0...40 (0...400)
Capacity for fuel, l not less than 2
The fuel supply mm3/cycle, not less than 1200
Price on request
