Calpeda GM 10. Drainage submersible pumps
Offer type: salePublished: 24.06.2016
| Price: | 1 000 UAH |
| Company: | ChP 'GidroAvtomatizatsiya' |
| Seller: |  D'yachenko Bogdan Vasil'evich |
| Phones: |  067-233-04-64 Show phone |
| Address: | Ukraine, Kirovohrads'ka Oblast', Kirovohrad |
Design pumps Calpeda GM 10.
Submersible drainage pumps, made of composite polymers developed especially for this type of pumps.
This is a new stainless steel materials, corrosion-resistant, non-deformable at the maximum temperature difference in the engine and pump, resistant to external and internal influences. The shaft is made from chrome steel AISI 430. The shaft has three o-rings of NBR.
Minimum size and maximum performance, wide application, flow up to 200 l/min.
Usage of float switch for automatic start and stop.
The use of pumps GM 10.
Pumps GM 10 produced by Italian company di-soric is designed for pumping clean or slightly polluted water, drainage of flooded rooms or baths the water intake from ponds, vodotokov, wells for rain water and irrigation.
The power cable length should not be less than 10 m.
Operating restrictions on pumps GM 10.
The maximum fluid temperature for continuous operation 30°C (with immersed motor).
Depth of immersion: max 5 m (with cable of appropriate length).
Not suitable for continuous operation for extended periods of time.
Special design of custom pumps GM 10.
For operation at other voltages.
To work with a frequency of 60 Hz.
Cable H07RN8-F, 4 G 1 mm2, length 10 m, without plug.
No float switch.
With a cranked tube on the in-feed funnel.
