Laminar module PWM
Offer type: salePublished: 21.07.2013
| Seller: |  Market Vyacheslav |
| Phones: |  +380938682488 Show phone |
| Address: | Ukraine, Kyiv Oblast', Kyiv |
Laminar module PWM creates a unidirectional air flow to ensure the specified parameters of purity in the required field. Design of laminar modules used in the creation of quiet zones and spaces. The main components of this module are the HEPA filter and fan, providing the class purity not lower ISO 5.
Main technical specifications
Case material - stainless steel AISI 304/2B or AISI 316 L "2B"
Protective mesh pre-filter and laminator anodized aluminum
Specially designed air duct, low pressure, preventing the risk of possible penetration of air in the clean zone, bypassing the filters and reduce the pressure loss, noise and irregularity laminar flow
Port for DOP/DOS
The possibility of equipping a differential pressure gauge
The sensor debris filter
Filtration efficiency HEPA filter H14 is 99,995% MPPS (0.3 μm), in accordance with standard EN 1822
Pre-filter G3 corresponding to the standard EN 779
Supply voltage 230V / 50Hz
Maximum power consumption for each module 620 watts.
The possibility of equipping different control panels (distant or built-in, automatic or manual adjustment of the flow rate of air)
The ability to create fixed or mobile laminar zones of different sizes and configurations
Manufacture according to GMP standards
Main technical specifications
Case material - stainless steel AISI 304/2B or AISI 316 L "2B"
Protective mesh pre-filter and laminator anodized aluminum
Specially designed air duct, low pressure, preventing the risk of possible penetration of air in the clean zone, bypassing the filters and reduce the pressure loss, noise and irregularity laminar flow
Port for DOP/DOS
The possibility of equipping a differential pressure gauge
The sensor debris filter
Filtration efficiency HEPA filter H14 is 99,995% MPPS (0.3 μm), in accordance with standard EN 1822
Pre-filter G3 corresponding to the standard EN 779
Supply voltage 230V / 50Hz
Maximum power consumption for each module 620 watts.
The possibility of equipping different control panels (distant or built-in, automatic or manual adjustment of the flow rate of air)
The ability to create fixed or mobile laminar zones of different sizes and configurations
Manufacture according to GMP standards
