Wire PTPI 2x0.8; 2x0.9; 2x1,2
Offer type: salePublished: 14.07.2014
| Seller: |  Valentina Ivanovna |
| Phones: |  +38(066)0285551 Show phone |
| Address: | Ukraine, Sums'ka Oblast' |
Wire dnapenny with galvanized steel electric conductors, insulated high-pressure polyethylene with a dividing base
The conductors, galvanized steel wire, with a diameter of 1.2 mm.
Isolation of high-pressure polyethylene of a thickness of 0.6 mm was imposed on two parallel arranged in the same plane as the conductors, with the dividing ground between them with the size of 0.5 x 2.0 mm
Application:
Cables are designed for installation of wire broadcasting networks.
Specifications:
Climatic design UHL and T category 3 according to GOST
Increased ambient temperature: + 60°C
Low ambient temperature conditions fixed installation: -40°C
The electrical resistance of the conductive strands:
with a diameter of 1.2 mm, max. (reference value): 140 Ohm/km
Electrical insulation resistance of not less than: 5000 Mω*km
Test voltage after 1 h of stay wires in water for 1 min: 1500
Breaking strength of wires:
for wires with a diameter of 0.6 mm, not more: 196 N
for wires with a diameter of 1.2 mm, not more: 784 N
Installation and wiring are performed at a temperature not lower than minus 10°C
The bend radius is not less than 10 times the outer diameter of the wire
Construction minimum length: 150 m
Warranty period: 4 years from the date of commissioning
Minimum life: 10 years
The conductors, galvanized steel wire, with a diameter of 1.2 mm.
Isolation of high-pressure polyethylene of a thickness of 0.6 mm was imposed on two parallel arranged in the same plane as the conductors, with the dividing ground between them with the size of 0.5 x 2.0 mm
Application:
Cables are designed for installation of wire broadcasting networks.
Specifications:
Climatic design UHL and T category 3 according to GOST
Increased ambient temperature: + 60°C
Low ambient temperature conditions fixed installation: -40°C
The electrical resistance of the conductive strands:
with a diameter of 1.2 mm, max. (reference value): 140 Ohm/km
Electrical insulation resistance of not less than: 5000 Mω*km
Test voltage after 1 h of stay wires in water for 1 min: 1500
Breaking strength of wires:
for wires with a diameter of 0.6 mm, not more: 196 N
for wires with a diameter of 1.2 mm, not more: 784 N
Installation and wiring are performed at a temperature not lower than minus 10°C
The bend radius is not less than 10 times the outer diameter of the wire
Construction minimum length: 150 m
Warranty period: 4 years from the date of commissioning
Minimum life: 10 years
