Drying complexes (300, 600 kg/h). Drying of sawdust, biomass. Dryer
Offer type: salePublished: 14.07.2018
The complex drying of the aerodynamic type (single-circuit) intended for drying the crushed material (waste and wood residues, sawdust, agricultural waste) in a stream of hot air.
The drying unit can be used both standalone and as part of a technological line on manufacture of fuel briquettes and pellets.
Performance
KS-1/300: 200-300 kg/h
KS-1/600: 500-600 kg/h
The resulting raw material moisture: 6-12 %.
Structure of the technological line
1. Sifter (calibrator).
2. Drying complex:
2.1. Heat from chimney flue gases.
2.2. The grate bars.
2.3. The boost pipe.
2.4. Line extenders.
2.5. The fan exhaust.
2.6. Cyclone.
The equipment
KS-1/300
Sifter [1,5-10 m3/h of 2.05 kW]
Drying complex [2,2 kW]
Control Cabinet
Total installed power: 4,25 kW.
KS-1/600
Sifter [1,5-10 m3/h of 2.05 kW]
The drying unit [5.5 kW]
Control Cabinet
Total installed power: 7,55 kW.
Attention!
1. The control Cabinet package is included.
2. Brick for heat source package is not included. It is possible to supply body heat.
Requirements to raw materials
The desired fraction of the raw material, mm: up to 5
Required raw material moisture at the inlet, %: up to 50
When exceeding the target at the desired moisture content of raw input 50%, the decline in performance and to obtain the desired performance, it is recommended to use Combi drying complex aerodynamic.
We also offer drying facilities drum-type, on the basis of AVM-0,65 and AVM-1,5.
Technological requirements
1. service line – 2 people per shift.
2. Area for installation of the line – 30-200 m2 (depending on configuration).
3. The ceiling height is 3.5 – 4.5 m (depending on configuration).
4. To comply with safety standards and provide comfortable working conditions, mandatory flue gases from the heat source in the ignition, planning, emergency stop and output gases from the cyclone.
Details specify at the Manager by phone companies. We will be glad to help You! Call us!