Machine "Orbit" for gas pipe cutting manual
Offer type: salePublished: 22.08.2014
| Seller: |  Sharapov Aleksej |
| Phones: |  (8452)760-850 Show phone760-860 Show phone |
| Address: | Russian Federation, Saratovskaya Oblast', Saratov |
Machine portable Orbit (Orbit manual is intended for oxygen cutting of steel pipes in field conditions and the conditions of industrial enterprises.
For portable Orbits do not need power supply, this is its main difference from "Orbit-BM".
The device and principle of operation
1.The machine consists of the following parts:
truck;
- tension device;
circuit;
the cutting block;
- belt;
2.Movement of the machine along the pipe is made by driving hook chain consisting of stamped parts type PC-30-600. The chain is detachable and can accumulate to the required length depending on the diameter of the cut pipe. Disconnect the chain is shift any of them are relatively nearby.
3.Block cutting machine consists of a support plate, fixed on the rod is fixed in the body of the truck. The design of the caliper allows you to set the cutter at different angles to the plane of the cut to move them relative to the rod, set the cutter perpendicular to the tangent passing through the point of cut, move and fix the cutter at different heights.
4.Gas feeding system of the machine provides control of the feed gas to the torch. From the ramp or cylinder gases supplied to the gas collector machine installed on the truck. From the collector precursor gases on the hoses go to the cutter.
For portable Orbits do not need power supply, this is its main difference from "Orbit-BM".
The device and principle of operation
1.The machine consists of the following parts:
truck;
- tension device;
circuit;
the cutting block;
- belt;
2.Movement of the machine along the pipe is made by driving hook chain consisting of stamped parts type PC-30-600. The chain is detachable and can accumulate to the required length depending on the diameter of the cut pipe. Disconnect the chain is shift any of them are relatively nearby.
3.Block cutting machine consists of a support plate, fixed on the rod is fixed in the body of the truck. The design of the caliper allows you to set the cutter at different angles to the plane of the cut to move them relative to the rod, set the cutter perpendicular to the tangent passing through the point of cut, move and fix the cutter at different heights.
4.Gas feeding system of the machine provides control of the feed gas to the torch. From the ramp or cylinder gases supplied to the gas collector machine installed on the truck. From the collector precursor gases on the hoses go to the cutter.
