Bizator  /  Adverts  /  petrochemical production  /  chemical products

Glue a T-REX Vulc. B for conveyor belt

Offer type: salePublished: 04.08.2019
Price:710 UAH
Company:KONVEJER SERVIS
Seller:Menedzher po prodazham
Phones:
Show phone
Write a message
Address:Ukraine, Odessa oblast', Odesa
Professional two-component glue T-REX Vulc. B for cold vulcanization (joining conveyor belts, lining drums, gumming of metal surfaces). Color: black. A volume of 700 g + 30 g hardener Supplier T-REX Rubber International, Netherlands (part of the group of companies REMA TIP TOP)

Instructions for bonding conveyor belt glue T-REX Vulc. B

Application areas two-component adhesive T-REX Vulc. B:

works on the lining of the drums
docking of conveyor belt cold vulcanization
gluing rubber to rubber
bonding rubber to metal and other materials
Application / bonding T-REX Vulc. B

Depending on the bonding material, it is necessary to prepare the material for bonding according to the instructions. Rubber, steel and fabric should be takerkoust. Do not allow oil, grease, dirt and moisture.

Attention! Observe the safety instructions on the boxes, labels and safety data sheet.

Activation of T-REX Vulc. B

Attention! Glue a T-REX Vulc. B must be mixed thoroughly first before and then after adding the hardener.

Work with activated clay T-REX Vulc. B

Application temperature from +10 °C to +40 °C. the durability at room temperature and a relative humidity of ≈ 65% is approximately 3 hours.

Application / bonding T-REX Vulc. B

Important! Depending on the bonding material, it is necessary to prepare material according to instructions. Rubber, steel and fabric should be takerkoust. Do not allow oil, grease, dirt and moisture.

Note that the first layer of adhesive applied to the surface, completely dry, and then apply the second layer the T-REX Vulc. B. After 5-10 minutes of drying the second layer (check the back of your hand - an easy tack of the adhesive) is achieved the maximum bonding ability of the surface to superimpose on each other and strongly pressed roll or roller, rubber-headed hammer, tap with a hammer, etc.
Important! When gluing rubber to metal is a mandatory condition of pre-coating the metal surface with primer T-REX Primer.

Important! When performing work on the connection conveyor belt - conveyor operation possible at least 4 hours after completion of the bonding.