Bizator  /  Adverts  /  petrochemical production  /  chemical products

Glue Elastosal H7 for the connection and repair of conveyor belts

Offer type: salePublished: 04.08.2019
Price:900 UAH
Company:KONVEJER SERVIS
Seller:Menedzher po prodazham
Phones:
Show phone
Write a message
Address:Ukraine, Odessa oblast', Odesa
Function: two-component adhesive ELASTOSAL H7 do not contain trichloroethylene, for connection of rubber-rubber, rubber-fabric, rubber-metal and fabric-fabric.

Applications: joining of conveyor belts, futerovka drums of belt conveyors, repair of conveyor belts

Advantages ELASTOSAL H7
Optimal viscosity, ELASTOSAL H7 is easier and more convenient to apply;
Long "durability" ELASTOSAL H7 up to 2 hours in an enabled state in a closed jar;
The best price among similar materials with other German manufacturers.

Product properties:

Polymer base: polychloroprene
Color: black
Hardener Härter RE (4% of the volume of glue)
Recommended surface cleaner for ELASTOSAL Lösit M

General instructions for use of glue ELASTOSAL H7

1. Surface preparation:

the prepared surface should be clean, dry, free from grease and oil. Surface better handle grinding wheel to easy the roughness preventing shiny spots.
The dust should be completely removed. For bonding rubber to metal the surface must be machine ELASTOSAL ® Metallprimer.

2. Mixing ELASTOSAL H7

Mix with hardener Härter RE ELASTOSAL (supplied) to be mixed thoroughly for 2-3 minutes. The service life of the mixture to 2 hours in a closed container.

3. Application ELASTOSAL H7

Requires 2 to 3 layers of glue. Apply a thin layer to both surfaces of an adhesive material. Drying: the first layer must dry thoroughly (30 minutes). The last layer should be dried so many time to when you test fingers layer was still tacky (10-20 minutes). In the case of drying out should apply a new layer of glue.

4. Bonding

Both parts need to impose on each other and hard to press (for example, by means of roller or hammer). It is also important to sticky the surface was in full contact with each other.

The best conditions for gluing are at 10 - 25 ° C and 30 - 65% relative humidity.

Sufficient strength can be achieved after 3 hours at temperature not below +20 degrees. The maximum bonding strength is achieved after 24 hours at temperature not below + 15 deg.

Information given for guidance only and to provide General information about the product and possibilities of its application. Is not a guide to action and the basis for any warranty. Please note that when joining any conveyor belt glue for cold vulcanization it is necessary to follow instructions of manufacturers of conveyor belts.
Ordering information: supplied in cartons 12 PCs ELASTOSAL H7 + hardener packaging 12 PCs.

ELASTOSAL® is a trademark of Unitec Helmsdorf GmbH, Germany