Piping detail from company "Ufimskiy Zavod detaley truboprovodov"

Ufimskiy Factory pipe offers a complete range of fittings. This is the tees and elbows all standard sizes. They are used to connect the main pipes for industrial use, as well as in the domestic sector. Products, for example, bends steel, is better to buy directly on the manufacturer's website at the lowest price.

The bends

These elements are designed to perform bends of pipes of any diameter. USDT uses two method of manufacture of taps: roll-formed from drawn tubes and welded. The main advantage of the seamless bent branches — a large mechanical strength. They have potentially weak points — the seams. Bent the withdrawal is made from a section of a pipe, which is bent in the heated the form of special equipment. It preserves the inner diameter. On the outer side of the bending occurs a thinning of the wall, therefore, for the manufacture of taps only suitable thick-walled pipes. The main application of seamless bent laterals — pipelines of high pressure.

Elbows welded

In comparison with curved bends have welded less weight. They can have thin walls and are distinguished by precise geometric dimensions. Welded elbows are used for air ducts, piping of liquids at low pressure and gravity pipeline systems. Optimum design of welded drainage is collected from three or four pipe sections. This ensures a smooth curve, the invariance of the cross section inside and no noise of fluid.

Special equipment for power objects

USDT produces specialized parts for power plants. It blocks steam pipelines, welded the bottoms, lugs and gasket for increased reliability of pipelines of thermal power plants. The equipment is applicable to power plants and boilers of all sizes, including the smallest. The main requirement for this type of equipment — large supply of strength and heat resistance. Products USDT certified and approved for use in the most critical areas.

UST also produces a wide assortment of other parts used in the construction of pipelines.