Cantilever pumps monoblock KM

Cantilever pumps of centrifugal type pumps console monoblock type KM are intended for submission to the stationary conditions clear or slightly turbid water, pH=6...9, a temperature of from 0 to 85°C (version "S" - single lip seal) or from 0 to 105, 120, 150°C ("5", "55" with mechanical seals) and other liquids similar to water in density, viscosity and chemical activity containing solids size up to 0.2 mm, the volume concentration not exceeding 0.1%, not aggressive to the material flow of the pump is cast iron.
Pumps console and console-monoblock pumps KM (units electric pump based on them) are not intended for use in explosive and fire hazard areas.

Design: cantilever centrifugal pumps, KM - pumps the horizontal location of the position of the shaft, axial suction and radial discharge nozzles. The flanges on the suction and pressure pipes comply with GOST 12820. Impellers of pumps hydraulically offloaded from the axial load. Thanks to technology design of pumps, KM, the dismantling of the bearing unit with impeller and seal node can be performed without removing the the pump casing from the piping.
Compared to pumps To pumps of the type KM have smaller overall the size and weight of the pump part is assembled directly on the shaft special motor with extended shaft). The undoubted advantages console-monoblock pumps KM above the pumps To you be attributed to the presence of one of the bearing unit, which makes their operation more reliable.

Designation structure of the pumping unit - ISO 2858.

Symbol cantilever pump (unit) when ordering, correspondence and technical documentation should be:
Pump (unit) TO (KM) 80 - 50 - 200 (NF-4, where:

K - pump console, KM - pump console-single block;

80 - diameter of pipe, mm;

50 - diameter, mm;

200 - nominal impeller diameter, mm;

With - designation seal (stuffing box).

NF-4 - climatic version and location category.

When the supply pump with one of the variants of the impeller outer diameter, is added to the index:

"a", "b" is reduced impeller diameter;

"m" is increased impeller diameter.

Designation structure of pump type For up to 1990.
Symbol cantilever pump (unit) when ordering, correspondence and technical documentation should be:
Pump (unit) C / 30 With U3.1, where:

K - pump console;

45 - nominal capacity, cubic meters per hour;

30 - nominal pressure;

With - designation seal (stuffing box).

U3.1 - climatic version and location category.

When the supply pump with one of the variants of the impeller outer diameter, is added to the index:

"a", "b" is reduced impeller diameter;

"m" is increased impeller diameter.

Supply pump units on their basis:

K8/18
K50-32-125
C/30
K65-50-160A
K65-50-160
C/30
C/30A
K-65-160
C-50-200
C-50-200A
C/20
C/20A
C-80-160
C-80-160A
K-65-200
K-65-200A

K-65-250
K-65-250a
K150-125-250
K160/30
C-125-315
C/30
C-150-250
C-150-315
C-150-400
KM50-32-125
KM65-50-160
CM-65-160
CM-50-200
KM100-80-160
KM100-65-200
CM-125-250

Delivery in Ukraine