Drying unit RTS-75

Installation drying RTS - 75 is designed for drying of raw materials.

Design installation of drying allows drying keplevagas and dries hard, mushy, pastes and granular materials.

Used the line at the distillery grains for fodder flour, where the pre-dewatered in a centrifuge to humidity 55-65 % raw enters the drying unit and is dried to a moisture content of not more than 10 %.

 Technical features

· The heat transfer surface, m2_______________________________ 75

· Steam pressure, MPa (kgf/cm2), not less______________________________ 0,5 (7)

· Steam consumption per kg of evaporated moisture, does not more_________________________ 1,65

· Humidity at inlet, %____________________________________ 55 - 65

· Performance of evaporated moisture, kg/h, not less than______________ 480

· The humidity of the product output, % ___________________________________ 10

· The diameter of the drive shaft, mm ___________________________________________ 1 000

· Diameter drive shaft with blades, mm ________________________________ 1 160

· Shaft rotation frequency, s-1 (about./min) _________________________________ 0,17 (10)

· Drivetrain: engine

power, kW ____________________________________________ 18,5

· Synchronous speed, s-1 (about./min) ___________________________ 16,7 (1000)

· Installed power, kW, not more ______________________________ 25,5

· Gearbox CU-250-31,5-12 N1

· Overall dimensions, mm

length ______________________________________ 6 050

width, not more____________________________ 2 200

height: without ventilation system_______________ 2 550

system ventilation_______________ 3 880

· Weight, kg, not less than________________________________________________ 9 650