Guillotine shears NC
Offer type: salePublished: 17.10.2014
| Seller: |  Zajtsev Yurij Aleksandrovich |
| Phones: |  (48266)5-28-03 Show phone 903-803-83-16 Show phone |
| Address: | Russian Federation, Tverskaya Oblast' |
Crank sheet guillotine shear with sloping knife NK designed for cutting sheet metal with a tensile strength na and with the largest cross-sectional sizes 6,Hm.
It is also possible cutting of non-metallic sheet materials, excluding rapid dulling of the cutting edges of the knives and the cracking of the cut sheet. Scissors are widely used in the procurement departments of the enterprises of mechanical engineering, tractor machine building, aircraft construction, shipbuilding, agricultural machinery and other industries, as they have higher performance than scissors series "ND", due to the lack of preparation time changeover mechanism for cutting different thicknesses of cut metal and mechanization of the rear stop
Specifications:
The thickness of the metal with the ultimate strength of 500 MPa (50 kgf/mm^2), 6,3 mm
The width of the metal, mm 2000
The greatest length of the cut strip at the rear focus, 700 mm
The dimensions of the scissors in the plan, mm
- from left to right 2780
- front to back (without lateral position) 1600
- the height of the scissors 1620
Height above floor level from the upper edge of the stationary knife 800 mm
Shears weight, kg 4250
Genus power supply AC three phase
Voltage, V 380
The number of motors 2
Main drive electric motor type 4AМC132SУ3
power, kW 8,5
rotation frequency, min - 1 1500
It is also possible cutting of non-metallic sheet materials, excluding rapid dulling of the cutting edges of the knives and the cracking of the cut sheet. Scissors are widely used in the procurement departments of the enterprises of mechanical engineering, tractor machine building, aircraft construction, shipbuilding, agricultural machinery and other industries, as they have higher performance than scissors series "ND", due to the lack of preparation time changeover mechanism for cutting different thicknesses of cut metal and mechanization of the rear stop
Specifications:
The thickness of the metal with the ultimate strength of 500 MPa (50 kgf/mm^2), 6,3 mm
The width of the metal, mm 2000
The greatest length of the cut strip at the rear focus, 700 mm
The dimensions of the scissors in the plan, mm
- from left to right 2780
- front to back (without lateral position) 1600
- the height of the scissors 1620
Height above floor level from the upper edge of the stationary knife 800 mm
Shears weight, kg 4250
Genus power supply AC three phase
Voltage, V 380
The number of motors 2
Main drive electric motor type 4AМC132SУ3
power, kW 8,5
rotation frequency, min - 1 1500
