The timing belts self-leveling

Standard timing belts require the use of pulleys with special provisions (ribs), non-ejection belt. If the use of such pulleys in any reason impossible, then you must apply samoupravlanja toothed belts.

A toothed belt with semi-circular tooth (BAT10, BAT15, BATK10, BATK15)

To achieve smaller noise was designed the configuration of the belts with curved teeth profile ( BAT). In addition to smooth running, this profile has a greater flank of the tooth than AT version and samoupravlenie strap in the right direction.

The strap has a semicircular shape of teeth cross-section, which provides a more uniform distribution load and prevents their lateral displacement during operation. The angle of the face of the trapezoid teeth is 50°.

For perfect centering applied belts with profile BAT (BATK with additional centre guide).

A toothed belt with a staggered arrangement of the tooth (SFAT10, SFAT15, SFAT20)

Profile cut two rows of teeth. These the teeth are offset by half a tooth pitch relative to each other. In combination with synchronous pulleys, the government will force the belt to work right. No flanges are not required.

The strap is made with a special offset of the teeth, providing a more smooth operation and uniform load distribution, which prevents lateral displacement of the belt during operation.

Strap notched V-guide (TK5K6, ATK5, K6, ATK10K6, TK10K6, TK10K13, ATK10K13, ATK20K13, TK1/2”K13)

Straps are a single combined structure of the toothed belt and the guide wedge is made in one working operation. Gear belts with guide wedge are most commonly used for strong side loads when the timing belt on the pulley without flanges.

Thanks the combined design of the toothed belt and the guide wedge, manufactured in one working operation, turn toothed belt, working without lateral displacement. They are used mainly in the transport equipment and equipment for loading and unloading.

Belt with a herringbone tooth (EAGLE 5M, EAGLE 8M, EAGLE 10M EAGLE 14M)

Tooth design Helical Offset Tooth (HOT) ensures continuous meshing of the teeth at an angle that allows the system to run quieter and with less vibration than any other toothed drive belts that exist at the moment.

Special materials used in the belts provide high performance and thermostability than their predecessors. The use of pulleys for timing belts without flanges also provides more compact and lightweight drives without prejudice to their efficiency.

Belts from polyurethane are manufactured the same types (Y, W, P, B, G, O, R) and rubber. Pick a belt difficult, because the tooth pitch and width they standard.