Thermoabrasion installing thermal jet cleaning
Offer type: salePublished: 28.02.2015
| Price: | 25 350 UAH |
| Company: | ChP Promsoyuz |
| Seller: |  Oleg Nikolaevich |
| Phones: |  (050)8604865 Show phone |
| Address: | Ukraine, Luhans'ka Oblast', Alchevs'k |
Thermoabrasion installation. Thermal jet cleaning.
Thermal abrasive cleaning is similar to abrasive blasting (sandblasting) processing, the difference in the temperature and gas flow rate. This technology impacts the surface of high-temperature supersonic jet, the carrier particles of abrasive material. Gas flow is generated by the combustion products of kerosene and diesel fuel burned in the compressed air in the combustion chamber of the burner. The burner provides input into the gas stream of abrasive particles and accelerating channel, allowing you to disperse them to the greatest possible velocity. The typical values of velocity and temperature of gas stream in the output section of the accelerating channel are 1250 m/s and 1400 K, respectively. The velocity of abrasive particles sostavljaet 100 - 300 m/s, depending on their faction and origin. The velocity of the particles in the 2.5 to 3.5 times higher than the rate in the traditional strainhardening processing, and the energy of the collision with the surface, respectively 6-10 times. It is high Kineticheskaya energy of abrasive particles determines the unique effectiveness of the technology thermoabrasion cleaning. Technology allows you to clean metal surfaces of all types of sogranenii and layers, such as metallurgical scale, corrosion products, paint,galvanische and thermal spray coatings, izvestnikovyh and other deposits. The quality of treated surface corresponds to the degree Sa3 according to ISO 8501-1:1988 (white metal).
Thermal abrasive installing TAU-100 (100 l).
Thermal abrasive installing TAU-200 (200 l).
Installation TAU can work in two modes - sandblasting sand blasting, thermal abrasive cleaning.
Thermal abrasive cleaning is similar to abrasive blasting (sandblasting) processing, the difference in the temperature and gas flow rate. This technology impacts the surface of high-temperature supersonic jet, the carrier particles of abrasive material. Gas flow is generated by the combustion products of kerosene and diesel fuel burned in the compressed air in the combustion chamber of the burner. The burner provides input into the gas stream of abrasive particles and accelerating channel, allowing you to disperse them to the greatest possible velocity. The typical values of velocity and temperature of gas stream in the output section of the accelerating channel are 1250 m/s and 1400 K, respectively. The velocity of abrasive particles sostavljaet 100 - 300 m/s, depending on their faction and origin. The velocity of the particles in the 2.5 to 3.5 times higher than the rate in the traditional strainhardening processing, and the energy of the collision with the surface, respectively 6-10 times. It is high Kineticheskaya energy of abrasive particles determines the unique effectiveness of the technology thermoabrasion cleaning. Technology allows you to clean metal surfaces of all types of sogranenii and layers, such as metallurgical scale, corrosion products, paint,galvanische and thermal spray coatings, izvestnikovyh and other deposits. The quality of treated surface corresponds to the degree Sa3 according to ISO 8501-1:1988 (white metal).
Thermal abrasive installing TAU-100 (100 l).
Thermal abrasive installing TAU-200 (200 l).
Installation TAU can work in two modes - sandblasting sand blasting, thermal abrasive cleaning.
