Test probes, leads GOST 882-75, measuring probes, calibrated probes

Set of test leads (probe) BALTECH FG is a calibrated plate defined the thickness. The probe is used to control the gap between the planes forming or curvilinear forms. The measuring probes is necessary to measure small distances (e.g., slightly thicker than a sheet of paper). Sets of probes measuring BALTECH FG widely used to measure gaps, for example, in the engine construction, to adjust valve clearance, radial clearance bearings and alignment equipment (definition of disclosure of the coupling and the exact definition of "soft paws") and other

Leads, as a rule, available as sets of plates of different thickness in the same clip. They can to be flat or wedge-shaped. Apply the probes separately or in different the combinations. Measurements with their help spend on the principle "is not passes". The measured gap injected one after the other flat plate from a set of probes up until one of the plates barely will enter the gap, and the following will not fit. When using the probe wedge shape, its gently insert into the gap until then, until it stops, then define its thickness specified on the front surface of the probe.

In the manufacture of sets of probes BALTECH FG uses a hardened, stainless steel or the brass. They are issued by length 75, 100, 150, 200, 300, 500, 1000 mm. Company BALTECH has also the supply of tape for producing probes thickness of from 0.01 to 2.0 mm, and also in order single probe measurement (with holder). The test probes can be a cylindrical or conical shape.

Advantages using a set of probes (probe) BALTECH FG:

• ease of use;

• high precision measurements.