Alignment of gearboxes, repair of gearboxes, seminars, service

Alignment of gears of different types must be performed by a series of "QUANTUM-CM", developed specialists BALTECH. Having experience in repairs of gearboxes for over 15 years and using laser alignment systems our experts have realized that 50% of success associated with the qualification and the availability of the necessary specialized tool. To help all users of laser alignment systems of any the brand we have developed a universal set of QUANTUM Professional". In fact, the main characteristics of industrial gearboxes, such as efficiency, involute gear teeth gears, transmission power, and the maximum angular velocity of the shafts largely depend on how well done the alignment of the gear relative to the drive units, as well as the geometry and alignment of the bearing supports. Accuracy the pair of bearings of the gearbox, we recommend to perform system laser alignment geometry BALTECH LL-9000. Designers and developers of power units, often try by selecting the type flexible coupling or cardan gear is to make alignment of the gears did not require hard tolerances. Practice shows that these measures are not enough. Alignment gears is an important task, the accuracy of this work depend on the load on shafts, gears and bearings. Fracture (crack) of the shafts, premature failure (jamming, breakage separators and gouges bearings) are often caused by the fact that the alignment of gears made with violations. In different industries: automotive, mechanical engineering, energy, paper and chemical industries, repair and technical maintenance of power units for the alignment of the gear system is used laser alignment of shafts and shafting. Several times the company's specialists BALTECH faced with the problem that when the repair install a new bearing rolling is not of appropriate quality. We recommend you to check all new the bearings on the stands incoming quality control bearings series "PROTON SPP".

Alignment systems series "QUANTUM-SEE" simple and does not require special user training. Convenience shaft alignment systems and machine trains "QUANTUM-CM" is that the alignment of the gears can be performed in real time for a single installation system, and to calculate the magnitude of the misalignment, the directions and magnitudes of adjustment drive motor, it is enough to crank shafts only at an angle of 60 degrees. It is very convenient, because very often the connection shaft of the gearbox and the drive mechanism is very closely located and it is not possible to crank shafts at an angle of 180 degrees. The alignment of the gears with precision metal plates BALTECH-12347 and systems "QUANTUM-CM", a really good recommendation confirmed our long practical experience. We invite all technical experts to attend our seminars Reliability technologies.