BALTECH - testing of bearings, bearing control - training courses

One of the main questions specialists serving equipment in the enterprise: "How to perform testing and inspection of bearings?"

There are several stages the life cycle of bearings:

1. The first stage. At this stage is the input control bearings when entering the enterprise. Here, as usually, there are so many variations of "artisanal" check so to speak " eyes". But now let's talk about the input control, which is based on the methodology All-Russian Scientific Institute Of The Bearing Industry. On this methodology the monitoring of bearings is carried out on the test stand bearings PROTON SPP". This stand, carrying out quality testing of bearings allows to identify in the party of counterfeit products. This stage is one of the key stages, so to prevent the installation of the equipment knowingly defective bearing is the main objective of all businesses.

2. The second phase. At this stage, the bearings last input control act at the warehouse, from which they already are installed directly in the equipment itself. At this stage it is important to monitor the quality of work equipment for break-in. And for this control there is a pretty extensive list of equipment. Starting from the usual simpliest vibration meters BALTECH VP-3405 or BALTECH VP-3410 and ending with advanced analyzers vibration and bench systems. One of the best options is for the time the running-in of equipment to install trap monitoring system CSI 2600, which will allow the continuous write signal operating equipment from which it will be possible to identify problems encountered during break-in and eliminate emergency the shutdown.

3. The third stage. This stage implies the life of the bearing to the refusal. At this stage, you can resort to several types of control the bearings. One of the most simple, simple simpliest vibration meters BALTECH VP-3405 or BALTECH VP-3410 and implement periodic monitoring vibration in accordance with GOST 10816. This device will allow for the level of vibration to see whether there is vibration within the tolerance. Generally, if the vibration is too high, the defect is already well developed and it is necessary to take measures to eliminate it.

There is a device BALTECH VP-3450 based on the method of drums pulses, which in contrast to his predecessor pulse vibration allows you to define an incipient defect.

For the implementation of advanced monitoring equipment often use modern vibration analyzers. One of the best to date, it vibratory complex CSI 2140, which allows the early to identify emerging defects, as well as to determine the type of defect. In addition this device, as well as poster CSI system 2600 may temporarily be installed on the equipment and write timing signal for few hours. As these systems allow on a professional level to extend the life of the bearings before the next repair that will to save not only your time to repair, but funds of the company on the replacement parts.

For full monitoring of bearings at all stages of life cycle it is recommended to have a good fleet of devices, and also to teach specialists. As of today, there are good courses.