Repair of pumps and pumping units, trainings and seminars, equipment

At the moment in the industry we use a lot of pumps of various types. This centrifugal, vortex, jet and so on. Pumping equipment is in some industries industry, secondary, where critical, but either way, the data the mechanisms used in any industrial enterprise. To conduct maintenance and repair of pumps use a variety of tools and measuring devices. To determine the defect or group of defects and to take the decision to repair pump use diagnostic devices industrial equipment. Such devices are signal analyzers (BALTECH VP-3470, "PROTON-Balance", the CSI 2140), thermal imaging camera BALTECH TR, alignment systems laser (series "QUANTUM", produced by Baltech LTD and Fixturlaser (Sweden)). This equipment allows to determine the direction of repair of pumps. Methods such as vibration analysis, thermal control, oil analysis and others allow us to monitor (monitor) pumps in working condition under load and to detect defects. This way equipment maintenance avoids unnecessary replacement of components pumps and make only necessary repairs. Diagnostic methods allow to determine the types of defect, such as imbalance, misalignment of shafts, wear seal the defects of the impeller, pipe joints, respectively, leads to the replacement or adjustment of only the defective parts in the repair of the pump. Maintenance and repair of pumps (of any industrial equipment) the above form is called the service on the actual condition (CFC).

To determine the above faults and defects and maintenance and repair pumps, the company will organize a service for the diagnosis, consisting of specialists for vibration diagnostics, alignment, oil analysis, and others, provide the necessary diagnostic equipment. Possible training specialists different directions diagnostic equipment (vibration diagnostics tribodiagnostics, centering, televisiony control, balancing and so on) the training center BALTECH in, St. Petersburg, Astana, Kiev.