The plant of Electromechanical products. Contactors electromagnetic
| Company: | TD PAO KPEMZ |
| Seller: |  menedzher |
| Phones: |  +7(499)999-12-46 Show phone |
| Address: | Russian Federation, Moscow |
The official representative of Kamenetz-Podolsk Electromechanical plant trading house TD PJSC "CPAS" implements unified industrial switches (contactors) with electromagnetic drive. They are designed for switching power supply circuits of electrical installations in industrial enterprises. The electromagnetic actuator makes it easy to integrate them into automation systems.
The main range of products are the most popular contactors series KT and KTP. They are designed for frequent operational switching of circuits under full load. The total number of switching cycles can be up to 1200 per hour. Abrasion resistance — not less than 300 thousand cycles. Exact specifications can be found on the official website, by following this link http://kpemz.com.ru/kontaktor-kt-6020.
Contactors series KT and KTP are intended for industrial three-phase 380 volts. Dielectric strength is higher — about 600 volts or higher depending on modifications. For three-phase current douglasiidae camera contactor are identical in construction, United by a common actuator. The opening of all three phases always occur at the same time. Additionally the factory can be ordered in two-pole contactors performance.
The main feature of a contactor — power. In industrial systems contactors are used for switching motors. When selecting it is necessary to consider that the starting current of the motor exceeds the nominal two to three times. The contactor must be designed for such overload, especially if the switching engine is running often.
The electromagnetic voltage control circuit can be low voltage (24 volts), and conventional (220 volts). In addition to series KT and KTP have intermediate options of 36, 48 and 110 volts. The current coil of the actuator — up to 5 amps depending on voltage. The output circuit of the relay controller (or other output device's control system) must be rated to handle the current. Contactors series CT and CTS are mounted stationary in space. Climate design allows them to operate in unheated premises.
