Finned tubular heater

Tubular heaters fin are used as components, in both domestic and industrial heating devices (heaters, electrical heaters, heaters, etc.). TANR designed for heating of air environments: stationary (S) and moving (O).

For more information, please look at the website http://ten-tena.com.ua

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

· L – the total length;

· Lo – the length of the fins;

· D – diameter of the shell;

· Do – diameter of the fins;

· h – step fins.

 

 

Example of designation of TENN:

 

 

 

 
Often the heaters are used finned air heating elements.It looks like a tube wrapped metal tape. Tape tightly podvalivaet to the tube for increased heat transfer. The capacity of the finned heating element is calculated from the fact that the heat transfer increases by about 25%.The tape itself orebrennye can be made of black or stainless steel. This is especially important in damp areas. Durability the heating elements may be considerably higher when using stainless tubing and tape orebrenie. When choosing rebernik heaters or finned tubular electric heater should to specify dimensional constraints, or required at the installation site dimensions. The methods of fastening Elements. It could be the choke plate. On the tube no voltage respectively can be fastened over the phone, but take into account that the thickness tube 1-2 mm and you can just burn through while welding . Forms rebernik heaters are the same as all other tubular. It can be a direct form like a pencil, 's horseshoe ridge fled, W - shaped. The diameter of ten with orebrennye from 28 mm to 33 mm. the tube 8-13 mm diameter. Tape with a width of 1 cm. Such technical details do not need to specify when you contact the manufacturer Heater, specify only the relevant features.

 

TANR is a tubular electric heating element, the casing of which is fixed a steel tape. Due to the increase the surface area increases the heat of the electric heater, in the result what, compared to perebranny heater, achieved an increase power.

Gebrauchte heating elements diameter: 8.0, 8.5, 10.0, 13.0, 16.0 mm

For finning applied tape width: 5.5, 7.0, 10.0 mm

Material PETN and ribbons: black or stainless steel

It is possible to manufacture, TANR with aluminum fins

Further for mounting, TANR in the equipment set of mounting fitting plate