Heater cartridge

 

Heater cartridge (TENP) -tubular heaters TEMP is a heater cartridge type (finger coil), the main feature of cartridge Heaters est design. Have cartridge heaters, TENP insights are one side of the tubular heater.

For more information, please look at the website http://ten-tena.com.ua

The conclusions of the finger heater heating element, in usually made of heat-resistant flexible cables. Heaters finger (cartridge Heaters) are used for heating molds, casting molds, water, fats and oils, weak solutions of acids and alkalis, air and used as components in industrial plant, extruders and household heating appliances.

 

 

 

Device TEMP

D - diameter of shell, mm

L - length of TEMP, cm

 

 

 

Lk - the length of the cold part of TENP

 

 

The structure of conditional refer to TENP:

TANP - L - D / P - U

Example :TEMP-10-12.5/0,4-220 contact terminals with a length of 40 mm

L is the length, cm

D - diameter, mm

P - power, kW

U - voltage, V

 

 

 

 

Technical capabilities manufacturing

 

Diameter of shell (D)

6.3 - 20 mm

Heater length (L)

4-100 cm

Cold part length(Lk)

From 10 mm

Pin length (Lp)

any

Power(kW))

0.01-5.0 kW

Voltage (V)

12-400

 

Options execution of conclusions:

1 - contact pins made of Nickel with a length of 40 mm;

2 - flexible wire with heat resistant insulation;

3 - flexible wire with heat resistant insulation in a metal braid;

4 - flexible wire with heat resistant insulation with additional protection from vibration;

The company takes orders from customers for other options and parameters, TEMP, specifically for each installation.

 

A distinctive feature of the cartridge electric heaters is the ability to create significant heat flow from the surface. Specific surface power can reach 20 W/cm2 or more.

 

Design of tubular electric heater cartridge of finned is arranged inside the metal shell izgotovleny in the form of a tube with a closed ( sealed ) party a heating element which is usually a spiral of material with a high resistance with the contact terminals positioned on one side cartridge heaters (P) and. From the shell, the heating element is insulated compacted insulating filler. For protection from falling moisture cartridge heaters from the environment, TENP end side of the contact pins sealed with a special sealant.

 

The shell is, as a rule, from stainless steel with brushed surface, providing a very tight fit the heating element to heat the body with a clearance in the diameter of not more than 0.02 mm. This is because that TEMP operate at high specific surface loads. The presence of even minimalnih, air gaps between the shell, TENP and the heated body leads an unacceptably high temperature of the spiral and the filler and, as a consequence, the output of the heater down.

Jacket diameter 6.5 – 20mm, Length of 40-100 cm, Power of 100-5000 W, the Tension 12-380 V, sheath Material stainless steel.steel.