Flat heaters

Flat heaters designed for injection molding machines (injection molding machines), extruders, granulators, injection molding machines and other equipment.

Flat heating elements are metal case (having different sizes), which is located inside insulated from the body of the heating element.

For more information, please look at the website http://ten-tena.com.ua

The flat body of the heater is made of their stainless steel (often steel 12KH18N10T). Heating element made of Nickel-chromium alloy of the highest quality. Used for electrical insulation heat-resistant inorganic materials sudoplatova, ceramic materials. Heaters are issued on rated voltage 12, 24, 36, 42, 48, 110, 127, 220, 380 V. It is possible to manufacture flat heating element with integrated thermocouple, controller power.

Insights contacts flat PETN can be made in the form of a connector plug or kettle, ceramic pads,pins with thread, insulated flexible thermoprotei.

We will consider any design of your flat heater and invite the manufacturer in the shortest possible time and at the best prices.

Flat heaters, the class is very similar to clamp. But there is a difference:

Pressure plate (only for flat) is made of aluminum alloy or steel. Necessary to ensure the quality of the pressing over the whole surface heater if the customer has no opportunity to make yourself.

Separate point and the main component of heating elements in General is the line resistive materials KANTAL and RESISTOM, and has about 30 options the cross-sectional shape, sectional area, temperature characteristic, specific resistance (Ohms) specific surface load (W/cm2), etc the manufacture of nagarwala specially selected the desired view given the conditions work.

From consumers, in turn, is required to provide quality eat temperature with ne. To do this:

o Ensuring the heated surface as smooth as the contact with the ne surface throughout the heated area.

o (Only for flat ne) Set on the heated surface a coupling device for enhanced pressing to her ne

o Cleaning the heated surface prior to installation of ne from dirt, carbon, dust, etc.

o If the heating surface has any damage in the form of shells, deep scratches, etc., before mounting the surface must be applied high temperature timeprovides pasta.

o Periodically pinch pinch devices ne because after heating the metal expands and the clamp is weakened, which in turn leads to insufficient heat sink and as a consequence, the release of ne from the system.