Sell plasma cutting machine CNR CUT 40

Apparatus for plasma cutting CNR CUT 40 is designed for cutting metal using plasma. The physical basis of air-plasma cutting is blowing electric arc compressed air, followed by local melting of the metal and removing it from the cutting zone, the preheated gas stream.

As the plasma temperature reaches tens of thousands of degrees, it is possible to cut any metals and their alloys, including carbon, stainless and high alloy steel, cast iron, copper, brass, bronze, aluminum, titanium, and composite material. Due to such a high temperature, cutting speed is several times higher than oxy-fuel cutting, and the process begins without preliminary heating of the metal.

This metal does not warp and is not deformed, and the Burr formed at the edges of the cut can be easily removed, then there is a smooth edge. In addition, the metal loss is minimal due to the small width of cut.

Advantages of plasma cutting CNR CUT 40:

• Because of the relatively small size and weight, the apparatus is easy to move.
• Welding machine is easy to use, easy to configure.
• Cutting all metals and their alloys, as well as carbon, stainless and high-alloy steels.
• The cutting speed is several times higher than oxy-fuel cutting.
• The process starts without preliminary heating of the metal.
• There is no warping of the metal.
• No deformation of the metal.
• Burr is formed on the cutting edges, it is easy to remove.
• Metal loss is minimal due to the small width of cut.
• High efficiency and performance.
• A high efficiency.
• High precision and cutting quality.
• The simplicity of the cutting process.
• The possibility of welding of the sheets immediately after cutting.
• The layer of paint, oil, rust and other metals will not affect the cutting process.

Specifications plasma cutting CNR CUT 40: The supply voltage 220 Volts Maximum power consumption 4.8 kW The limits of current regulirovaniya 10-40 Amps Management smooth Ignition contactless The open-circuit voltage 220 Volts The thickness of the cut metal 10 mm clean cut, 12 mm separation Type of cooling forced The mode of operation (MO) 60 percent Brand CNR Dimensions 371X155X295 Weight 8 kg